Owners manual

REV. DATE: 3/17/2016 Page 5 of 7
Step-4 Use a reference point on the vehicle, measure and adjust the winch tray so the side to side
alignment on the vehicle is equal, then finger tighten all factory and supplied nuts and bolts securing the
winch tray and frame brackets, (Photo 11 & 12).
If you are installing a winch, place the winch in the winch tray and refer to the winch manufacturer’s
instructions for installation. Do not install the fairlead at this time.
Step-5 With assistance lift the bumper shell up to the vehicle, align the holes in the bumper brackets
with the weld nuts on the winch tray and secure the bumper shell brackets to each side of the winch tray
using (3) ½” x 1 1/2” hex bolts, (3) ½” lock washers and (3) ½” flat washers, (Photo 13 & 14). Leave the
bolts loose for final adjustment.
#11
Driver
Side
#12
#13
Driver
Side
#14
Driver
Side