Owners manual

REV. DATE: 3/17/2016 Page 4 of 7

BR10 Bumper Replacement Installation

Step-1 Remove the nuts bolts and tow hook from the frame, (Photo 7). Note: The tow hook will not be

reinstalled.

Step-2 Install the driver’s side frame bracket by positioning the bracket on the side and bottom of the

frame, align the holes and secure the bracket to the frame using (2) ½” x 1 ½” hex bolts, (2) ½” flat

washers, (2) ½” lock washers and (2) ½” hex nuts, (Photo 8). Leave the nuts and bolts loose for final

adjustment. Repeat this step to install the passenger side frame bracket.

Step-3 Rest the winch tray on top of the frame brackets. Position one of the spacer plates between the

winch tray mounting flange and frame, align the spacer plate with the (2) upper holes in the frame and

winch tray mounting flange and reinstall the (4) factory bolts. Position the remaining spacer plate

between the winch try flange and frame on the passenger side and reinstall the factory bolts. Secure the

winch tray to each frame bracket using (3) ½” x 1 ½” carriage bolts, (3) ½” flat washers, (3) ½” lock

washers and (3) ½” hex nuts, (Photo 9 & 10). Leave the nuts and bolts loose for final adjustment.

Driver

Side

#10

Driver

Side

Driver

Side

Driver

Side