Owners manual

REV. DATE: 3/17/2016 Page 2 of 7
IMPORTANT INSTALLATION NOTES AND SUGGESTIONS
The pre-installed Mesh Winch and Vent Covers need to be removed using hand tools to slowly remove
the bolts. Using an air assisted impact or ratchet will damage the bolt threads and the internal nut
assembly in the bumper shell. Use of an appropriate anti-seize compound is highly recommended for re-
installation, and tighten the bolts to the specified torque as overtightening could result in difficulty of
future removal.
To maintain and care this product keep it clean and do not use abrasive cleaners or polish waxes.
Texture Painted Finish: Mild liquid detergent may be used. Polished Stainless & Semi-Gloss
Painted Finishes: We recommend using only non-abrasive automotive wax such as pure carnauba to
avoid scratches and rust.
Read the installation instructions completely and verify that all of the parts listed are accounted for. If
you have defective, missing or damaged parts or need assistance, please contact Go Rhino Products
for fast, friendly customer service at: [phone] or email: [e-mail]
Front Bumper Removal
Step-1 Open the hood and locate the (12) plastic push pins (6) per side securing the radiator cover.
Using a flat blade screw driver, pull the head of the push pins up, remove push pins and lift radiator
cover off. This will allow access to the bolts securing the top of the grille, (Photo 1).
Step-2 Remove the (4) screws (2) per side securing the top of the grille, (Photo 2).
#1
#2
Tool Required:
7mm, 10mm, 15mm, 18mm, 21mm, 7/16”, 9/16” & 3/4” Sockets
18mm, 7/16”, 9/16” & 3/4” Wrenches
Slotted Blade Screw Driver
5/32” Hex Key
Ratchet, Ratchet Extensions & Swivel Joint Adapter
Approximate installation time: 90 min.