Owners manual

REV. DATE: 3/16/2016 Page 9 of 9
If installing a winch, install the roller fairlead to the bumper shell at this time. Refer to the winch
manufacturer’s instructions for installation. If installing an optional light bar, install the light bar to the
bumper replacement at this time. Refer to the light bar instructions for installation.
Step-16 Install the driver and passenger side front vent covers and winch cover to the bumper shell
using the supplied ¼” x ¾” button head bolts, (Photo 9). Note: Do not over tighten bolts, reference
tightening torque (71 in. lbs.).
If your vehicle is equipped with front park assist reconnect the factory bumper wiring harness to the
sensors and to the vehicle wiring harness prior to installing the winch cover.
Step-17 Install the flush mount light pods to the bumper shell using (4) ¼” x ¾” button head bolts and (4)
¼” nylon lock nuts, (Photo 9).
Step-18 Re-connect the vehicle battery or batteries.
If your state law requires a front license plate, attach the license plate bracket to the holes in the face of
the bumper shell, using the supplied 3/8” bolts, washers and nuts, and the license plate to the (2)
obround holes in the license plate bracket using the supplied ¼” bolts and nuts, (Photo 10).
If installing a winch, attach the license plate directly to the (2) obround holes in the lower face of the
bumper shell using the supplied ¼” bolts and nuts, (Photo 10).
Remember to check and retighten all factory and supplied nuts and bolts periodically.
Photo 10
Photo 9
Passenger
Side