Owners manual

Step-12 Position the front edge of the mounting plate/winch tray 8 5/8” forward from the face of the
frame, (Photo 5). Center and level the mounting plate/winch tray with the vehicle then tighten the factory
bolts securing the frame brackets, and the supplied nuts and bolts securing the mounting plate/winch
tray to the frame brackets, (Photo 6). Do not tighten the auxiliary bracket nuts and bolts at this time.
If you are installing a winch, place the winch in the winch tray and refer to the winch manufacturer’s
instructions for installation. Do not install the fairlead at this time.
Step-13 With assistance lift the bumper shell up to the vehicle, align the holes in the bumper shell
brackets with the weld nuts on the mounting plate/winch tray and secure the bumper shell to each side
of the mounting plate/winch tray using (3) ½” x 1 1/2” hex bolts, (3) ½” lock washers and (3) ½” flat
washers, (Photo 7). Leave the bolts loose for final adjustment.
Step-14 Align the holes and attach each factory bumper support bar to each of the bumper shell support
brackets using the factory M10 bolt, (1) M10 flat washer, (1) M10 lock washer and (1) M10 hex nut,
(Photo 8).
Step-15 With assistance, adjust and hold the bumper shell visual alignment position, then tighten all
factory and supplied nuts and bolts. Note: It may be necessary to loosen the nuts and bolts securing the
mounting plate/winch tray and brackets.
REV. DATE: 3/16/2016 Page 8 of 9
Photo 5
Passenger
Side
Photo 6
Passenger
Side
Photo 7
Driver Side
Photo 8
Passenger
Side