Owners manual

REV. DATE: 3/16/2016 Page 6 of 9
Step-4 Install the inner sensor bezels and sensors in the supplied bezel plates, (Illustration 1). From the
side with applied tape, line up the protrusions on the bezel with the profile in the bezel plate; push the
bezel through the profile in the plate until the tabs around the base lock in position, then install the
sensor in the bezel. Note: The U notch in the sensor plates designate the top, and the V notch on the
side position toward the center of the vehicle.
Step-5 Install the outer sensor bezels and sensors in the driver and passenger vent covers, (Illustration
1). Line up the protrusions on the bezel with the profile in the vent cover; push the bezel through the
profile in the vent cover until the tabs around the base lock in position, then install the sensor in the
bezel. Do not install the vent cover at this time.
Step-6 Prepare the inside of the replacement bumper surface where the inner bezel plates will be
mounted with Isopropyl alcohol. A clean, dry surface is required in order for tape to stick properly.
Step-7 Peel the backing off from the double sided tape to uncover the adhesive. From inside the
replacement bumper position each bezel, sensor and bezel plate assembly, making sure the sensor
bezel is centered in the hole provided in the replacement bumper.
Step-8 Stick the assembly in place and apply firm pressure for about 30 seconds. The tape needs to
bond with the mounting surface, and it needs pressure to do this. The bezel mounting plate will seem
like it is stuck on, but continue pressing for at least 30 seconds. Note: At room temperature
approximately 50% of ultimate bond strength will be achieved after 20 minutes, 90% after 24 hours and
100% after 72 hours.
ILLUSTRATION 1