Owners manual

REV. DATE: 3/16/2016 Page 5 of 9
Step-12 On each side of the vehicle, remove (3) bolts securing the bumper bracket to the frame, (Photo
11). Retain the bolts as (2) of the bolts will be used to secure the bumper replacement frame brackets to
the vehicle.
Step-13 If equipped remove the nut and (2) bolts’ securing the tow hooks to the frame, (Photo 12). Note:
The tow hooks will not be reinstalled.
Step-14 Reinstall the factory grille.
BR5 Bumper Replacement Installation
Note: If your vehicle is not equipped with front Park Assist install the supplied plastic plugs in the holes
in the replacement bumper and vent covers and proceed to step 9.
Step-1 If the vehicle is equipped with front Park Assist, disconnect the sensors from the factory bumper
wiring harness and remove the wiring harness from the bumper.
Step-2 Remove each sensor from the plastic bezel by gently spreading the bezel tabs and pulling out on
the back of the sensor. Note: Do not push on the front of the sensor as this may damage the sensor.
Step 3 Remove the sensor bezels from the factory bumper by depressing the tabs around the base and
pushing the bezel out through the front of the bumper. Note: The sensors and bezels have to be
positioned in the replacement bumper in the same location (inner and outer), (driver and passenger) as
removed from the factory bumper.
Photo 11
Passenger
Side
Photo 12
Passenger
Side