Owners manual
REV. DATE: 3/17/2016 Page 3 of 6
Step-3 If equipped, disconnect the wiring harness from each of the fog lights, (Photo 3).
Step-4 Remove the bolts (3) per side securing the outer bumper support bar to the body mount bracket and to the
bumper using a 15mm socket and ratchet, (Photo 4).
Step-5 Remove the nut and bolts’ securing each of the tow hooks to the frame using an 18mm wrench, socket,
and ratchet, (Photo 5). Pull the hooks out from the front and remove from the vehicle.
Step-6 Remove the nuts (2) per side from the paired bolts securing the bumper brackets to the frame using a
21mm socket and ratchet, (Photo 5). Caution: Do not remove the paired bolts.
Step-7 With assistance support the bumper, remove the paired bolts; pull the bumper down, and forward away
from the vehicle. Retain the nuts and paired bolts to attach the replacement bumper brackets.
Step-8 Remove the (4) remaining plastic push in connectors and the rubber splash shield from the vehicle, (Photo
6). Discard the splash shield.
#3
Driver
Side
#4
Driver
Side
#6
Driver
Side
#5
Driver
Side