Owners manual

REV. DATE: 2/3/2017 Page 9 of 9
If installing a winch, install the roller fairlead to the bumper shell at this time. Refer to the winch manufacturer’s
instructions for installation. If installing an optional light bar, install the light bar to the bumper replacement at this
time. Refer to the light bar instructions for installation.
Step-19 Install the driver and passenger side front vent covers and winch cover to the bumper shell using the
supplied ¼” x ¾” button head bolts, (Photo 13). Note: Do not over tighten bolts, reference tightening torque (71 in.
lbs.).
If your vehicle is equipped with front park assist, reconnect the factory bumper wiring harness to the sensors and
to the vehicle wiring harness prior to installing the winch cover.
Step-20 Install the flush mount light pods to the bumper shell using (4) ¼” x ¾” button head bolts and (4) ¼” nylon
lock nuts, (Photo 13).
Step-21 Re-connect the vehicle battery or batteries.
If your state law requires a front license plate, attach the license plate bracket to the holes in the face of the
bumper shell, using the supplied 3/8” bolts, washers and nuts, and the license plate to the (2) obround holes in
the license plate bracket using the supplied ¼” bolts and nuts, (Photo 14).
If installing a winch, attach the license plate directly to the (2) obround holes in the lower face of the bumper shell
using the supplied ¼” bolts and nuts, (Photo 14).
Remember to check and retighten all factory and supplied nuts and bolts periodically.
#14
#13
Passenger
Side