Owners manual

REV. DATE: 2/3/2017 Page 8 of 9

Step-15 Assemble the passenger side support bracket and one of the support bracket extensions using (2) 3/8” x

1 ¼” hex bolts (4) 3/8” flat washers (2) 3/8” lock washers and (2) 3/8” hex nuts. Sung but do not fully tighten the

bolts. Install a 3/8” flat washer on one of the 3/8” x 5” hex bolts and position the bolt through the lower set of holes

in the tow hook frame stanchion with the threads protruding toward the outside of the vehicle. Secure the support

bracket assembly to the side of the tow hook frame stanchion using the 3/8” x 5” hex bolt (1) 3/8” flat washer, (1)

3/8” lock washer and (1) 3/8” hex nut, (Photo 9). Repeat this step to assembly and install the driver side support

brackets.

Step-16 With assistance lift the bumper shell up to the vehicle, align the holes in the bumper shell brackets with

the weld nuts on the mounting plate/winch tray and secure the bumper shell to each side of the mounting

plate/winch tray using (3) ½” x 1 1/2” hex bolts, (3) ½” lock washers and (3) ½” flat washers, (Photo 10). Leave

the bolts loose for final adjustment.

Step-17 Align the holes and attach bumper support bracket to each of the bumper shell support brackets using

(1) ½” x 1 ½” hex bolt, (2) ½” flat washers, (1) ½” lock washer and (1) ½” hex nut, (Photo 11).

Step-18 With assistance, adjust and hold the bumper shell visual alignment position, then tighten all nuts and

bolts. Note: It may be necessary to loosen the nuts and bolts securing the mounting plate/winch tray and

brackets, (Photo 12).

Passenger

Side

#10

Passenger

Side

#11

Passenger

Side

#12