Owners manual

REV. DATE: 2/3/2017 Page 7 of 9
Step-13 Place the mounting plate/winch tray on top of the auxiliary brackets. Align the holes and secure the
mounting plate/winch tray to each frame bracket using (2) ½” x 1 ½” carriage bolts, (2) ½” flat washers, (2) ½” lock
washers and (2) ½” hex nuts, and to each auxiliary bracket using (3) ½” x 1 ½” carriage bolts, (3) ½” flat washers,
(3) ½” lock washers and (3) ½” hex nut, (Photo 5 & 6).
Step-14 Position the front edge of the mounting plate/winch tray 8 5/8” forward from the face of the frame bracket,
(Photo 7). Center and level the mounting plate/winch tray with the vehicle then tighten the nuts and bolts securing
the passenger and driver side frame brackets, and the nuts and bolts securing the mounting plate/winch tray to
the frame brackets, (Photo 8). Do not tighten the auxiliary bracket nuts and bolts at this time.
If you are installing a winch, place the winch in the winch tray and refer to the winch manufacturer’s instructions
for installation. Do not install the fairlead at this time.
#5
Passenger
Side
#6
Passenger
Side
#7
Passenger
Side
#8
Passenger
Side