Owners manual

REV. DATE: 2/3/2017 Page 5 of 9
Step-4 Install the inner and outer sensor bezels and sensors in the supplied bezel plates, (Illustration 1). From the
side with applied tape, line up the protrusions on the bezel with the profile in the bezel plate; push the bezel
through the profile in the plate until the tabs around the base lock in position, then install the sensor in the bezel.
Note: The U notches in the sensor plates designate the top, and the V notches on the side position toward the
center of the vehicle.
Step-5 Install the middle sensor bezels and sensors in the passenger and driver vent covers, (Illustration 1). Line
up the protrusions on the bezel with the profile in the vent cover; push the bezel through the profile in the vent
cover until the tabs around the base lock in position, then install the sensor in the bezel. Do not install the vent
cover at this time.
Step-6 Prepare the inside of the replacement bumper surface where the inner bezel plates will be mounted with
Isopropyl alcohol. A clean, dry surface is required in order for tape to stick properly.
Step-7 Peel the backing off from the double-sided tape to uncover the adhesive. From inside the replacement
bumper position each bezel, sensor and bezel plate assembly, making sure the sensor bezel is centered in the
hole provided in the replacement bumper.
Step-8 Stick the assembly in place and apply firm pressure for about 30 seconds. The tape needs to bond with
the mounting surface, and it needs pressure to do this. The bezel mounting plate will seem like it is stuck on, but
continue pressing for at least 30 seconds. Note: At room temperature approximately 50% of ultimate bond
strength will be achieved after 20 minutes, 90% after 24 hours, and 100% after 72 hours.
ILLUSTRATION 2