Owners manual

REV. DATE: 2/3/2017 Page 4 of 9

Step-9 Support the factory bumper, and on each side of the vehicle, remove the (3) nuts securing the bumper

connecter bracket to the flange on the end of the frame rail, (Photo 7). With assistance, remove the bumper from

the vehicle, (Photo 8).

Step-10 Reinstall the factory grille and radiator dust cover.

BR5 Bumper Replacement Installation

Note: If your vehicle is not equipped with front Park Assist, install the supplied plastic plugs in the holes in the

replacement bumper and vent covers and proceed to step 9.

Note: If you are replacing a bumper with front Park Assist, the sensor detection zone will be altered with use of

this bumper replacement.

Step-1 If the vehicle is equipped with front Park Assist, disconnect the sensors from the factory bumper wiring

harness and remove the sensor wiring harness from the bumper.

Step-2 Remove each sensor from the plastic bezel by gently spreading the bezel tabs and pulling out on the back

of the sensor. Note: Do not push on the front of the sensor as this may damage the sensor.

Step 3 Remove the sensor bezels from the factory bumper by depressing the tabs around the base and pushing

the bezel out through the front of the bumper. Note: The sensors and bezels have to be positioned in the

replacement bumper in the same location (inner, middle, and outer), (driver and passenger) as removed from the

factory bumper.

Passenger

Side