Owners manual

REV. DATE: 2/3/2017 Page 2 of 9
IMPORTANT INSTALLATION NOTES AND SUGGESTIONS
The pre-installed Mesh Winch and Vent Covers need to be removed using hand tools to slowly remove the bolts.
Using an air assisted impact or ratchet will damage the bolt threads and the internal nut assembly in the bumper
shell. Use of an appropriate anti-seize compound is highly recommended for re-installation, and tighten the bolts
to the specified torque as overtightening could result in difficulty of future removal.
If you are replacing a bumper with front Park Assist, the sensor detection zone will be altered with use of this
bumper replacement.
To maintain and care this product keep it clean and do not use abrasive cleaners or polish waxes.
Texture Painted Finish: Mild liquid detergent may be used. Polished Stainless & Semi-Gloss Painted
Finishes: We recommend using only non-abrasive automotive wax such as pure carnauba to avoid scratches
and rust.
Read the installation instructions completely and verify that all of the parts listed are accounted for. If you have
defective, missing, or damaged parts or need assistance, please contact Go Rhino Products for fast, friendly
customer service at: [phone] or email: [e-mail]
Factory Bumper Removal
Step-1 Open hood and disconnect the vehicle battery or batteries.
Step-2 Remove the (6) plastic tree clips securing the radiator cover to the radiator support. Using a flat blade
screwdriver, pull the head of the tree clip up, remove the tree clips, and lift radiator dust cover off. This will allow
access to the bolts securing the top of the grille, (Photo 1).
Step-3 Remove the (4) screws securing the top of the grille to the radiator support, (Photo 2). Unsnap the pins
located behind the grille on each side midway and bottom, and then remove the grille from the vehicle.
Tools Required: 3/8” & ½” Drive Sockets / 8mm, 10mm, 13mm, 15mm, 18mm, 7/16”, 9/16” & 3/4”
Wrenches / 8mm, 10mm, 13mm, 15mm, 18mm, 7/16”, 9/16” & 3/4”
Slotted Blade Screw Driver
5/32” Hex Key
3/8” & ½” Drive Ratchet, Ratchet Extensions & Swivel Joint Adapter Approximate installation time: 2 hrs.
#1
#2