Solar Controller User Manual (GP-PWM-30-UL)

GP-PWM-30-UL
_______________________________________________________________________
27
© 2019 Go Power!
Open the app, and the
Main page will prompt
you to select devices.
To pair, press and hold
the A and B buttons of
the charge controller
simultaneously for 3
seconds until the
Bluetooth
®
symbol on
the charge controller’s
display starts flashing.
Once this pairing
process has been
initiated on the charge
controller, select the
charge controller in the
Device Selection main
page of the Go Power!
Connect app.
Device selection must be performed while the Bluetooth
®
symbol is still flashing
on the charge controller’s display. The flashing state will last for 60 seconds. If
the charge controller is not selected on the Go Power! Connect app within this
time, the pairing process is canceled, and the A and B buttons must be long
pressed again.
Selecting the device will finalize the pairing process and a connection will be
automatically established. The Bluetooth
®
symbol on the charge controller’s
display will become solid and the monitor page of the Go Power! Connect App
will be started.