Product Manual

GPTS-30

___________________________________________________________

2. Installation

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

2.1 Disconnect Power

Make sure the generator is off, the external power cord is unplugged, and the

inverter, if any, is shut off.

2.2 Mounting Location

The TS-30 mounting location may be on any interior surface where the unit will

be out of direct weather. The chosen location must be accessible after

installation is complete to facilitate future servicing. If possible, mount the TS-30

near the power cord entry or the location of the generator output. Typical

locations include under counter cabinets, below closet compartments, inside the

bed pedestal or cabinets, overhead cabinets, under-floor storage compartments

accessed from the vehicle exterior, etc.

CAUTION: To prevent exposure to foreign contaminants, do not mount

the transfer switch in an engine compartment under kitchen sink drains

or water pipes within the battery compartment or any compartment

designed for storage of flammable liquids such as gasoline.

2.3 Electrical Preparation

Any numbered knockout on the TS-30 can be used for installation. Choose a

knockout that will facilitate installation and service within the selected mounting

area.

2.4 Mounting

Mount the TS-30 with screws through holes provided in bottom corners of the

can. The unit should be screwed to a solid surface firmly enough to hold its

weight during vehicle operation.

2.5 Electrical Connections

1. Attach an 8-gauge chassis ground wire to the transfer switch ground bar. A

direct access hole to the ground bar is provided through the enclosure for

convenience.