Owner's manual

Go Power! Smart Charger

Owner’s Manual

3. LED Status Troubleshooting

Problem and

Symptoms

Possible Cause Solution

“Red” LED Blinking Battery is disconnected Check the battery

connection

Battery fault Change battery

LED light off No AC power delivering Check input power

connection

Polarity reverse Change cables to the

correct polarity.

- Check DC fuse, if broken

replace the fuse.

Thermal Shutdown Make sure ventilation is not

obstructed.

Improve ventilation.

Reduce ambient

temperature.

3.1 Selection of battery types:

Use only Wet Lead Acid batteries or Lead Acid batteries with a bulk setting of 14.3V or

higher. The GP-1210 voltage settings are not adjustable.

Model No Battery Capacity (Min.) Battery Capacity (Max.)

GP-1210 12V / 30 Ah 12V / 100 Ah

4. Warranty

We warrant this product against defects in materials and workmanship for a period of 12

months from the date of purchase and will repair or replace any defective Go Power!

Battery Charger when directly returned, postage prepaid, to the manufacturer. This

warranty will be considered void if the unit has suffered any obvious physical damage or

alteration either internally or externally, and does not cover damage arising from

improper use such as plugging the unit into unsuitable power sources, attempting to

operate products with excessive power consumption requirements, reverse polarity, or

use in unsuitable climates.

This is the only warranty and the company makes no other warranties, express or

implied, including warranties of merchantability and fitness for a particular purpose.

Repair or replacement are your sole remedies and shall not be liable for damages,

whether direct, incidental, special or consequential, even though caused by negligence

or other fault.