Go Power! Owner’s Manual GP-TS Transfer Switch
1.0 Warnings Avoid All Electrical Hazards. Disconnect batteries and electrical system from 120/240 VAC, or any other power source of electrical power, before attempting to install your Go Power! GP-TS Kit. Observe proper polarity throughout the GP-TS Kit installation. Work Safely. Do not wear jewelry when working with electrical or mechanical equipment. Use protective eyewear, gloves and apron when working with batteries or power tools. Use extreme caution when on ladders or a roof.
Owner’s Manual | Go Power! – Transfer Switch Kit 3.0 Installation 1. Ensure the shore power plug is not connected to shore power and batteries are disconnected. 2. Connect the RV shore power cord to Go Power! Transfer Switch input: wires are labeled “Shore Hot” and “Shore Neutral”. Connect ground wire to provided ground bonding block. 3. Connect transfer switch output to AC power panel. (Use terminals labeled “AC Panel”). 4. Plug supplied inverter power cord into inverter.
Owner’s Manual | Go Power! – Transfer Switch Kit 3 Carmanah Technologies Corp.
© 2011, Carmanah Technologies Corp. www.carmanah.com | www.gpelectric.com Technical Support: customerservice@carmanah.com Toll Free in Canada and the U.S.: 1.866.247.6527 International: + 250.380.0052 | Fax: 1.866.607.
