User Manual

[page 12] | gpelectric.com
GENERAL INFORMATION
2.4 GP-SW1500TS FEATURES
4
5
6
7
8
3
2
1
ON / OFF / REMOTE- Use this button to turn the inverter ON, OFF or to switch the
inverter into REMOTE MODE.
Status LED - This LED is used to display (1) Input Voltage Level, (2) Output Load Level,
(3) Fault Conditions (see page 30).
Function Switch - This dip switch controls output voltage, output frequency, power saving
parameters (see page 31).
DC Negative Input Connector - Use these connection points to secure the battery bank
negative cable to the Inverter.
DC Positive Input Connector - Use these connection points to secure the battery bank
positive cable to the Inverter.
Chassis Ground - Use this connection to ground the exposed chassis of the inverter to
the chasis ground with wire # 8 AWG.
AC Output - Use these terminals to connect the AC loads (appliances) to the Inverter.
By-pass AC Input - Use these terminals to connect the AC shore power to the Inverter.
1
2
3
6
7
8
4 5
9
1011
12