User Manual

Table Of Contents

GP-PWM-30

________________________________________________________________________

3.0 Tools and Materials Needed

• Phillips Screwdriver

If the GP-PWM-30 Controller was purchased with a Go

Power! RV Solar Power Kit then UV resistant wire is

included. For instructions regarding the Go Power! RV

Solar Power

Kit installation, please refer to the

Installation Guide provided with the Kit.

4.0 Choosing a Location

The GP-PWM-30 is designed to be mounted flush against a wall, out of

the way but easily visible.

The GP-PWM-30 should be:

• Mounted as close to the battery as possible

• Mounted on a vertical surface to optimize cooling of the unit

• Indoors, protected from the weather

In a RV, the most common controller location is above the refrigerator.

The wire from the solar array most commonly enters the RV through the

fridge vent on the roof. PV connections should conn

ect directly to the

controller. Positive and negative battery connections must connect

directly from the controller to the batteries. Use of a positive or negative

distribution bus is allowed between the controller and battery as long as

it is properly sized, electrically safe and an adequate wire size is

maintained.