User's Manual

GO MBW Getting Started Guide
GO MBW Getting Started GuideGO MBW Getting Started Guide
GO MBW Getting Started Guide
Draft Version - Confidential - Page 32
To use HyperTerminal:
From the Start menu, select All Programs > Accessories > Communications >
HyperTerminal. Once you have defined a new connection, right-click and select
Properties. You should then set or verify the above values.
After the connection between the WLS and the laptop (or PC) is established, you will
need to enter your user name and password. Your user name determines what
authorization level you have and in turn determines whether you can view
configuration and operation parameters, or implement changes. The default super
user name is Super and the default password is Super. A new user and password
name should be added, however this default name and password can be used for the
initial configuration. The default system name for the unit is set to WLS.
Step 1: Configure the Fast Ethernet Interface
Define the static IP address and the subnet mask on the same network through
which you connect to the WLS. You can use the CLI command:
configure interface FastEthernet 0 ip address <ip address>, as
shown below:
configure interface FastEthernet 0 ip address 192.168.30.102
255.255.255.0
The default is DHCP mode.