User's Manual

GO MBW Getting Started Guide
GO MBW Getting Started GuideGO MBW Getting Started Guide
GO MBW Getting Started Guide
Draft Version - Confidential - Page 31
Configuring the WLS
Following is a brief overview of the main CLI commands that are used to configure
the WLS. A configuration example follows the detailed list of configuration
commands. These and other CLI commands are detailed in the GO MBW CLI
Reference Guide.
Connect and Access the WLS
You can connect to the WLS using a laptop or standard computer. Using an RS232
interface DB-9 cable, connect the COM port of the laptop to the WLS unit’s consol
port. For more information, see Appendix A, Wiring Specifications.
Notebook PC
Consol Port:
RS232
Consol Port:
RS232
Consol Port:
RS232
Consol Port:
RS232
WLS
Once connected, you can then operate a terminal program, such as HyperTerminal,
to configure the WLS unit to the following specifications:
• Baud rate = 9600
• Data bits = 8
• Parity = none
• Stop bits = 1