User's Manual

- Page 18 of 24 -
All contents are Copyright © 2007 GO Networks, Inc. All rights reserved.
Ethernet Connection
Ethernet connection is used for wired backhaul connection or an interface
to a third party wireless BH solution. Use outdoor rated CAT5 shielded
cables or better. The outer diameter of the Ethernet cable should be 4.8
7 mm. When using CAT5 shielded cables the cable can be up to 100
meters.
Following is a diagram explaining how the Ethernet cable should be
assembled prior to connecting it to the MBW 1100 (WLP) unit:
Figure 11: Ethernet Cable Connector
Power Connection
The MBW 1100 (WLP) unit can be connected to an AC power source by one
of several methods. It can be connected directly to a power source or by
using an optional adapter to connect to the streetlight photocell (photo-
control). The MBW 1100 (WLP) unit can support input voltage of 100 to
240 VAC (50 to 60 Hz).
Note: Connect the grounding cable before connecting any other cables.
When removing the MBW 1100 (WLP), the grounding cable should
be the last cable removed.
Noter: Connecter la prise de terre 10 AWG avant de connecter tout autre
câble. Pendant la désinstallation du MBW 1100 (WLP), la prise de
terre doit être le dernier câble retiré.
To connect the AC power to the MBW 1100 (WLP) via the streetlight
photocell:
1. Check the input voltage to the streetlight photocell. The voltage
must be between 100 to 240 VAC. If yes, continue with this
procedure. Otherwise, use a different method for the power
connection.
2. Remove the streetlight photocell. Turn the photocell
counterclockwise and lift the photocell out of the socket.