User's Manual

- Page 13 of 24 -
All contents are Copyright © 2007 GO Networks, Inc. All rights reserved.
Mounting the Antennas
The MBW 1100 (WLP) supports six antennas. Four WiFi antennas used for
user access, which operate on the 2.4 GHz band, marked A1 to A4. Two
antennas are used for the mesh networking connections, marked B2 and
B3.
To mount the antennas on the MBW 1100 (WLP):
1. Attached the four 2.4 GHz band antennas to terminals A1 to A4 and
screw all antennas into place by hand. Rotate each antenna at its
metallic base. The antennas should rotate easily. Tighten the
antenna by hand only. Do not apply excessive force by using any
tool, as this may damage the unit.
2.4 GHz
Antennas
Terminals
A1-A4
Figure 6: 2.4 GHz Band Antennas Installation
2. Insert the four 2.4 GHz band antennas into the Antenna Support
Plate. The antennas must be inserted evenly, so that the plate is
level and all the antennas are protruding the same. Use caution not
to change the alignment of the MBW 1100 (WLP).
Antenna
Support Plate
2.4 GHz
Antennas
Figure 7: Antenna Support Plate Installation