User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 3 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
GO Wireless LAN Pico Base Station (WLP)
The GO Wireless LAN Pico Base Station (WLP) complements the Wireless
LAN Sector Base Station (WLS). It delivers street-level coverage and
provides capacity enhancements in dense metro areas over a single
802.11b/g channel, while meshing traffic over an 802.11a radio.
The WLP Base Station delivers omni-directional (360
o
) coverage while
retaining full xRF smart antenna engine functionality for enhanced capacity
and range.
WLP Package Components
The WLP package items are listed in Table 1:
DESCRIPTION REV QTY
Wall/Poll Mount Kit Assembly (new) 1.0 1
Connectors Kit for WLP Package 1.0 1
WLP unit 1.0 1
WLP Access Antenna 2.4GHz 7.4dBi Gain,
Omni 4
802.11a 5Ghz 10dBi Omni Antenna
(Backhaul) 2
Photocell Power Adapter with cable length
o
6 ft (180cm) 1
Antenna Support Plate 1
Table 1: WLP Package Contents
Deployments of gateway devices connected by wire to an indoor
switch/router would include installation of a lightning protector. A lightning
protector is not supplied as part of the standard package. It can be
ordered from GO Networks as an accessory.
Specific installation may require different Power/Ethernet connections. See
Cable Connections
for more details.