User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 35 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
TFTP Upgrade Example
go>
go> /import image from tftp <ip address> <filename>
go> /show messages software-download
Software download started.
Verifying server and path.
TFTP path OK.
Flash erase started.
Flash erase finished.
Download started from 192.168.30.103 gapsw-1.3.5.11995-Beta-
28.02.2006@180244.img.
Download finished.
Verification started.
Verification passed.
Writing to environment.
Software download finished.
URL Software Upgrade
URL software upgrade may be used to load software directly from an HTML
link or an FTP server.
To upgrade the software via URL use the following command:
import image from url <url link>
When uploading from an FTP site, the URL link has to be formatted as
follows:
ftp://user:password@host:port/path and filename
To upgrade the software version:
a. Use the import image from tftp/url command.
b. Wait for the “Software download finished” message.
c. Reboot the system by using the “reload” command.
To observe the software upgrade progress use the following command:
show messages software-download