User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 21 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
Once the cable is connected, you can then operate a terminal program,
such as HyperTerminal. The PC port should be configured as follows:
Baud rate = 9600
Data bits = 8
Parity = none
Stop bits = 1
Flow control = None
Note:
New laptops may not include an RS-232 serial port. If a serial port is
not available, you may use a USB to serial converter.
To use HyperTerminal:
From the Start menu:
1. Select All Programs > Accessories > Communications >
HyperTerminal.
2. Define a new connection.
3. Right-click and select Properties. Set or verify the above values.
4. Click OK.
Figure 13: HyperTerminal Configuration
5. Establish the connection between the WLP and the laptop (or PC).
6. Log in using the predefined “super” user (user: super; password:
super).
The user name determines the authorization level and determines whether
the operator can view configuration and operation parameters, or
implement changes. A new user and password name should be added.