User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 20 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
Configuring the WLP
Following is a brief overview of the main CLI commands that are used to
configure the WLP. A configuration example follows the detailed list of
configuration commands. These and other CLI commands are detailed in
the GO MBW CLI Reference Guide.
Connect and Access the WLP
Initial configuration of the WLP is done using a serial cable. A standard
RS232-interface DB-9 cable is connected to the COM port of a laptop or a
PC to the WLP unit’s console port. For more information regarding the
serial cable, see Appendix B, Wiring Specifications.
Once the WLP IP address is configured, the rest of the configuration can be
done using Telnet via the network.
Figure 12: Connect and Access the WLP
Notebook PC
Consol Port:
Consol Port:
RS232
WLP
RS232