User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 18 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
4. Insert the photocell into the Auxiliary Power Adapter. Align the
larger prong on the photocell with the larger slot in the socket on
top of the adapter. Insert the photocell into the socket and rotate
the photocell clockwise.
5. Connect the Auxiliary Power Adapter cable to the power connector
socket on the WLP.
6. After connecting the power, verify that the Power (PWR) LED is lit.
7. Check the photocell. Cover the photocell and verify that the
streetlight operates.
Console Connection
Figure 11 illustrates the RS-232 cable connections used to connect the
WLP to a console (notebook computer to configure the WLP).
Figure 11: Connect and Access the WLP
Note: New laptops may not include an RS-232 serial port. If a serial port is
not available, you may use a USB to serial converter.
Notebook PC
Consol Port:
Consol Port:
RS232
WLP
RS232