User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 15 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
Table 4 lists the WLP Connectors Kit parts:
Item
No.
Description Qty
Picture
A
Solderless Ring
Terminal
1
B
Sealed RJ45
connector
1
Table 4: Mounting Kit Part List
Cable Installation Tools
The following special tools are required to install and connect cables related
to the WLP.
Slotted Screwdriver
1/8” (3mm) wide
Terminal Crimp Tool
RJ45 Crimp Tool
HT-210A
Volt Meter
Table 5: Cable Installation Tools and Equipment