User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 13 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
To mount the antennas on the WLP:
1. Attached the four 2.4 GHz band antennas to terminals A1 to A4 and
screw all antennas into place by hand. Rotate each antenna at its
metallic base. The antennas should rotate easily. Tighten the
antenna by hand only. Do not apply excessive force by using any
tool, as this may damage the unit.
2.4 GHz
Antennas
Terminals
A1-A4
Figure 6: 2.4 GHz Band Antennas Installation
2. Insert the four 2.4 GHz band antennas into the Antenna Support
Plate [J]. The antennas must be inserted evenly, so that the plate is
level and all the antennas are protruding the same. Use caution not
to change the alignment of the WLP.
Antenna
Support Plate
2.4 GHz
Antennas
Figure 7: Antenna Support Plate Installation
3. Attached the two 5 GHz band antennas to terminals B1 and B2.
Tighten the antennas by hand at it metallic base. The antennas
should rotate easily. Do not apply excessive force by using any tool,
as this may damage the unit.