User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 12 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
WLP Unit
Bolt
Flat Washer
Nut
Spring Washer
Figure 4: WLP Unit Mounting
2. Once the WLP unit is mounted, release the bolts slightly and align
the WLP unit horizontally using the level, as shown in Figure 5.
When the unit is perfectly aligned, firmly close all bolts, applying
120 inch-lbs of torque.
Figure 5: Aligning the WLP
Mounting the Antenna
The WLP supports six antennas. Four WiFi antennas used for user access,
which operate on the 2.4 GHz band, marked A1 to A4. Two antennas are
used for the mesh networking connections, which operate on the 5 GHz
band, marked B1 and B2.