User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 11 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
6. For wall mounting:
a) Fasten the wall/poll bracket [A] to the wall using four 3/16”
(5mm) bolts, as shown in Figure 3. Use the appropriate bolts
and fasteners, which is dependent on the material of the wall.
Wall-mounting bolts and fasteners are not supplied with the
mounting kit.
b) Place the wall/poll bracket [A] at the appropriate location
where you wish to place the unit. Using the four holes at the
corners of the bracket, mark the location where the fasteners
need to be installed.
c) Install the four fasteners in the wall.
d) Insert the four bolts through the bracket and securely fasten
the bracket to the wall.
Wall Mounting Holes
Figure 3: Bracket Wall Mounting
Mounting the WLP
To mount the WLP unit:
1. After assembling the brackets, mount the WLP unit on to the
bracket as shown in Figure 4. Use a flat washer [G], a spring washer
[H] and a nut [I].