User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 9 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
"L" Adapter
Hex Bolt
Flat Washer
Spring Washer
Figure 1: Mount ‘L’ Assembly
Mounting Brackets
To secure the mounting brackets:
1. Select an optimal mounting location on the pole. Select the highest
mounting location with minimal obstacles to the antennas for
optimal performance.
NOTE: When mounting the WLP on a pole, it should be placed
on a pole that can support four times the weight of the
WLP, as well as the wind loading created by the WLP.
2. Installation of the mounting brackets to a streetlight arm or a pole
differs according to the width of the pole, as illustrated in Figure 2.
Narrow pole
1"-1.75"
Normal pole
1.75"-3"
large pole
Grater then 3"
Figure 2: Pole Bracket Assembly