User's Manual
Table Of Contents
- Table of Contents
- Introduction
- GO Wireless LAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Configuring the Management Connectivity
- Configuring the Device Prompt
- Configuring the Radio Settings
- Configuring Multiple SSIDs
- Deleting an SSID
- Configuring the Mesh Network
- Configuring WDS CPE connection
- Configuring Authentication Types
- Configuring the Radius Client in the WLP
- Configuring Privacy Methods
- Saving the Configuration
- WLP Configuration Example
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 8 of 38 -
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
Item
No.
Description Qty Picture
H Spring Washer M8 4
I Nut M8 1
J Antenna Support Plate 1
Table 2: Mounting Kit Part List
Hardware and Connectors Installation Tools
The following tools are required to mount the WLP on a pole.
Combination Wrench (13 mm)
13 mm
Level
Table 3: Mounting Tools and Equipment
Note: All hardware and tools used for assembling and mounting the WLP
are Metric.
To assemble the ‘L’ adaptor [C] to the WLP unit:
• Attach the ‘L’ adapter to the WLP using an M8 x25 hex bolt [E], a
spring washer [H], and a flat washer [G], as illustrated in Figure 1.