User's Manual
Table Of Contents
- Trademarks and Licensing Agreement
- Introduction
- GO WLAN Pico Base Station (WLP)
- Installation
- Configuring the WLP
- Connect and Access the WLP
- Upgrading the WLP Software
- Appendix A: List of Acronyms
- Appendix B: Wiring Specifications
- Page 16 of 31-
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
Once the cable is connected, you can then operate a terminal program,
such as HyperTerminal. The PC port should be configured as follows:
d. Baud rate = 9600
e. Data bits = 8
f. Parity = none
g. Stop bits = 1
h. Flow control = None
To use HyperTerminal:
From the Start menu:
1. Select All Programs > Accessories > Communications >
HyperTerminal.
2. Define a new connection.
3. Right-click and select Properties. Set or verify the above values.
4. Click OK.
Figure 8: HyperTerminal
5. Establish the connection between the WLP and the laptop (or PC).
6. Log in using the predefined “super” user (user: super; password:
super).
The user name determines what authorization level the operator has and,