User's Manual

- Page 9 of 31-
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
Table 2: Mounting Kit Part List
First connect the ‘L’ adaptor [C] to the WLP unit. As seen in Figure 1, the
‘L’ adapter is connected using an M8 [E] bolt, a washer spring [H], and a
flat washer [G]. You must connect the ‘L’ adaptor on its normal-hole side
and not on it grooved side.
Figure 1: Mount ‘L’ Assembly
After preparing the unit with the ‘L’ adaptor, install the brackets. Assembly
of the mounting brackets in a lamppost or a pole installation differs
according to the width of the pole. Use two M8 bolts [D] with spring
washers [H] to install the brackets onto narrow (1”–1.75”) and normal
(1.75”–3”) poles, as illustrated in Figure 2. For poles larger than 3” in
diameter, install the bracket using 13 mm width hose clamps (not supplied
with the unit).
Narrow pole
1"-1.75"
Normal pole
1.75"-3"
large pole
Grater then 3"