User Manual

To ground the MBW 510 unit:

1. Crimp the solderless ring terminal [A] contained in the MBW 510

Connectors Kit to the grounding cable.

2. Attach the solderless ring terminal [A] to the bottom of the MBW

510 unit using the grounding screw.

3. Connect the other end of the grounding cable to a proper ground.

Note: Connect the 10 AWG grounding cable before connecting any other

cables. When removing the MBW 510, the grounding cable should be

the last cable removed.

Noter: Connecter la prise de terre 10 AWG avant de connecter tout autre

câble. Pendant la désinstallation du MBW 510, la prise de terre doit

être le dernier câble retiré.

Ethernet Connection

Ethernet connection is used for wired backhaul connection or an interface

to a third party wireless backhaul solution. Use outdoor rated CAT5

shielded cables or better. The outer diameter of the Ethernet cable should

be 4.8 – 7 mm. When using CAT5 shielded cables the cable can be up to

100 meters.

Following is a diagram explaining how the Ethernet cable should be

assembled prior to connecting it to the MBW 510 unit:

Figure 9: Ethernet Cable Connector

- Page 16 of 22 -