User's Manual

- Page 15 of 24 -

Figure 9: 5.4 GHz or 4.9GHz Third Band Antenna Installation

Cable Connections

When the MBW 1100 (WLP) is properly aligned, the connecters are located

at the bottom of the unit.

Cable requirements are often unique to the location and deployment

topology of each installation. As a result of this limitation, the Ethernet and

grounding cables are not included in the installation kit.

The following cables are required to install the MBW 1100 (WLP) unit and

should be connected in the following order:

• Grounding Cable – Provides the necessary electrical safety

functions.

• Ethernet Cable – Required only for MBW 1100 (WLP) units

connected to a wired network.

• Power Cable – Supplies AC power to the MBW 1100 (WLP) unit.

• RS-232 Console Cable – Provides a connection from the MBW

1100 (WLP) unit to a console (laptop computer) for configuration.

This is only required when the MBW 1100 (WLP) unit is not pre-

configured. This cable is not provided with the MBW 1100 (WLP)

unit. It is recommended that the MBW 1100 (WLP) is pre-configured

prior to installation.

Table 4 lists the MBW 1100 (WLP) Connectors Kit parts: