User's Manual

- Page 10 of 24 -

Figure 2: Pole Bracket Assembly

3. For narrow poles (1”–1.75” diameter):

a) Place the two brackets, [A] and [B], around the pole at the

approximate height where you wish to place the unit. When

placing the clamping bracket [B], the small notch side should

be in contact with the pole.

b) Use two M8x70 hex bolts [D] and spring washers, insert them

through both brackets and tighten them around the pole so

that the two brackets are securely fastened.

4. For normal poles (1.75”–3” diameter):

a) Place the two brackets, [A] and [B], around the pole at the

approximate height where you wish to place the unit. When

placing the clamping bracket [B], the large notch side should

be in contact with the pole.

b) Use two M8x70 hex bolts [D] and spring washers [G], insert

them through both brackets and tighten them around the

pole so that the two brackets are securely fastened.

5. For poles larger than 3” in diameter:

a) The wall/poll bracket [A] and two 0.5" (13mm) wide stainless

steel hose clamps (not supplied with mounting kit) are used.

The hose clamps must be the appropriate size to fit around

the pole and bracket.

b) Open the each hose clamp by rotating the screw on the clamp

counterclockwise. There may be additional resistance just

before the clamp is completely open. This is normal and you

should continue rotating the screws until the clamps are open.