User Manual

6 7
3.4 Place headset in base unit
charge cradle and charge a
minimum of 30 min. before use.
A full charge takes about 2 hours.
Visual indicator on headset will
fl ash green while headset is
charging, and light steady green
when fully charged.
3.5 Turn on headset by pressing
Hook button for 3 sec. (visual
indicator will light green for 3
sec.), or by placing headset in
base. Turn off by pressing Hook
button for 3 sec. (visual indicator
will light red for 3 sec.).
3.4
3 sec
3.5
4.3 If dial tone is missing or
unclear, slide the Clear dial tone
switch on bottom of base unit
through the 3 settings.
4.4 Set switch to the position that
gives the clearest dial tone.
Setting transmit (TX)
volume
4.5 Make a call (see section 5) to
someone who can act as a test
person.
4.6 Adjust outgoing volume with
Transmit (TX) volume control on
base unit. Switch through the 3
settings until test person confi rms
the appropriate volume.
1)
Setting incoming volume
4.7 During a call, adjust incoming
volume by pressing Volume button
on headset.
4.8 A tone in headset will
indicate when min./max. volume is
reached.
4.3
4.4
4.6
4.1
4. Optimizing
4.2
Clearest dial tone
4.1 Put on headset.
4.2 Lift handset from telephone
and listen for a dial tone in
headset.
4.7 4.8
4.5
1)
Note: If echo is heard transmit volume is probably too high.