User Manual

EN
3 CHARGING YOUR JABRA CLIPPER
Make sure that your Jabra CLIPPER is fully charged before you start
using it for the rst time. While charging, the battery indicator changes
from red to green when fully charged. Charging time is approximately
2hours. You can use the Jabra CLIPPER during charging. Please note:
The lifetime of the battery will be signicantly reduced if your device is
left uncharged for a long period. Jabra therefore recommends that you
recharge your device at least once a month.
4 TURNING YOUR JABRA CLIPPER ON AND OFF
Press and hold the Multi-Function button until the LED turns green to
turn it on.
Press and hold the Multi-Function button until the LED turns red to turn
it o.
The headset will automatically turn o after 10 minutes if not connected
to a device.
5 PAIRING YOUR JABRA CLIPPER TO A PHONE OR
OTHER DEVICE
Headsets are connected to phones or other Bluetooth® devices using a
procedure called ‘pairing’. By following a few simple steps, pairing can be
done in a matter of seconds.