User's Manual

4
English
5
English
If your telephone has a headset
port, go directly to 3.2b.
3.1 Unplug the handset cord from
your telephone and connect it to
the port on the base unit marked
with
.
3.2a Connect the enclosed
telephone cord to the now empty
handset port on the telephone,
and to the port on the base unit
marked with
.
3.2b (Only for use on phones
with a headset port) Connect the
enclosed telephone cord to the
headset port on telephone, and
to the port on base unit marked
with
.
3.3 Connect the AC power adapter
to the port on the bottom of
base unit, then plug the adapter
into the AC power outlet. If the
headset power supply is discon-
nected, the indicator on the base
will flash green.
3. Setting up your desk phone
3.1
3.3
3.2
Note: The AUX port is used for Remote Handset Lifter (RHL). Please refer to the Appendix.
4.1 4.5
4.6
4.7
4.8
4.2
4.3
4.4
3.4 Place the headset in the
charge cradle and charge for a
minimum of 30 min. before
use. A full charge takes about
2 hours. The visual indicator
on the headset will flash green
while headset is charging, and
the light will remain steady green
when fully charged. The same
procedure is to be followed when
using the travel charger.
3.5 Turn the headset on by
pressing the Answer/End button
for 1 sec. (the visual indicator will
flash blue four times and headset
will beep three times), or by
placing headset in charge cradle.
Turn the headset off by pressing
the Answer/End button for 2 sec.
(visual indicator will flash blue
four times and headset will beep
three times).
3.4
3.5
3.8
3.6
Clear dial tone
3.6 Take the headset out of
charge cradle and put it on.
3.7 Pick up the telephone handset
and listen for a dial tone through
the headset.
3.8 If dial tone is missing or unclear,
slowly slide the clear dial tone
switch on bottom of base unit
through the 3 settings.
3.9 Set the switch to the position
that gives the clearest dial tone.
4.1 4.5
4.6
4.7
4.8
4.2
4.3
4.4
2 sec
5.1
5.2
5.3
5.4
4.1 4.5
4.6
4.7
4.8
4.2
4.3
4.4
3.7
3.9