User Manual
Table Of Contents
- HS820 Wireless Headset with Bluetooth® Technology
- Welcome
- Contents
- Safety and General Information
- Introduction
- Using Your Headset
- Charging Your Headset Battery
- Wearing Your Headset
- Placing the Headset on Your Ear
- Changing for Wear on the Left Ear
- 1 Open the earhook (90˚ from the headset).
- 2 Gently lift and pull the top of the earhook up and off the upper hinge pin. Then pull it away to remove it.
- 3 Flip the headset over.
- 4 Hook the bottom of the earhook onto the lower hinge pin, then lift and pull the top of the earhook over the upper hinge pin.
- 5 To change the volume button orientation, see “Adjusting Headset Volume” on page 15.
- 1 Open the earhook (90˚ from the headset).
- Pairing Your Headset and Phone
- Pairing
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- 2 Perform a device discovery from the phone. For details on device discovery for your phone, refer to the phone’s user’s guide.
- 3 Select the Motorola HS820 from the discovered devices list and confirm following the on screen prompts.
- 4 When prompted by the phone, enter the passkey 0000 and confirm to pair the headset with the phone.
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- Pairing to Additional Devices
- Adjusting Headset Volume
- Making and Receiving Calls
- Using Your Headset Indicator LED
- Pairing
DR
AFT
17
flashing resumes. If you press the up and down volume
buttons at the same time during a call, the pulsing LED turns
off for the duration of that call.
Audio Tones
Audio Tone Headset Status
Single high tone when
pressing volume button
volume maximum or
minimum reached
Five rapid high tones,
repeated every 20 seconds
low battery
No audio indications;
deteriorating audio quality
out of range
Series of 4 tones, low to
high
audio link open (Headset
mode), active call (hands
free mode)
Ring tone incoming call
Single high tone pairing confirmation
Single low tone initiate voice activation
Dual high/low tone voice tag not recognized
Single high tone end call
Series of 4 tones, high to
low
audio link closed (Headset
mode), call ended (hands
free mode)
Fast high/low tone every
5
seconds (max. & min.
volume confirm beep)
no network/service
No tone power ON/OFF