User Manual
Table Of Contents
- HS820 Wireless Headset with Bluetooth® Technology
- Welcome
- Contents
- Safety and General Information
- Introduction
- Using Your Headset
- Charging Your Headset Battery
- Wearing Your Headset
- Placing the Headset on Your Ear
- Changing for Wear on the Left Ear
- 1 Open the earhook (90˚ from the headset).
- 2 Gently lift and pull the top of the earhook up and off the upper hinge pin. Then pull it away to remove it.
- 3 Flip the headset over.
- 4 Hook the bottom of the earhook onto the lower hinge pin, then lift and pull the top of the earhook over the upper hinge pin.
- 5 To change the volume button orientation, see “Adjusting Headset Volume” on page 15.
- 1 Open the earhook (90˚ from the headset).
- Pairing Your Headset and Phone
- Pairing
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- 2 Perform a device discovery from the phone. For details on device discovery for your phone, refer to the phone’s user’s guide.
- 3 Select the Motorola HS820 from the discovered devices list and confirm following the on screen prompts.
- 4 When prompted by the phone, enter the passkey 0000 and confirm to pair the headset with the phone.
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- Pairing to Additional Devices
- Adjusting Headset Volume
- Making and Receiving Calls
- Using Your Headset Indicator LED
- Pairing
DR
AFT
16
Note:
If the link abnormally disconnects (for example, out of
range) the headset tries to reestablish the link.
Using Your Headset Indicator
LED
With charger plugged in:
With no charger plugged in:
Note:
When the wireless headset is paired to the phone and
there is no activity for 5
minutes, the blue flashing LED turns
off. Any button press on the headset, resets the timer, and the
Headset Indicator Status
ON charging in progress
OFF charging complete
Headset Indicator Status
OFF power off
ON (steady) pairing mode
10 rapid flashes pairing successful
Flashes at a 3-second
interval
(.1 seconds ON
2.9
seconds OFF)
standby (not on a call)
Pulses at an 8-second
interval
(2.0 seconds ON,
6.0
seconds OFF)
connected (on a call)