User Manual
Table Of Contents
- HS820 Wireless Headset with Bluetooth® Technology
- Welcome
- Contents
- Safety and General Information
- Introduction
- Using Your Headset
- Charging Your Headset Battery
- Wearing Your Headset
- Placing the Headset on Your Ear
- Changing for Wear on the Left Ear
- 1 Open the earhook (90˚ from the headset).
- 2 Gently lift and pull the top of the earhook up and off the upper hinge pin. Then pull it away to remove it.
- 3 Flip the headset over.
- 4 Hook the bottom of the earhook onto the lower hinge pin, then lift and pull the top of the earhook over the upper hinge pin.
- 5 To change the volume button orientation, see “Adjusting Headset Volume” on page 15.
- 1 Open the earhook (90˚ from the headset).
- Pairing Your Headset and Phone
- Pairing
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- 2 Perform a device discovery from the phone. For details on device discovery for your phone, refer to the phone’s user’s guide.
- 3 Select the Motorola HS820 from the discovered devices list and confirm following the on screen prompts.
- 4 When prompted by the phone, enter the passkey 0000 and confirm to pair the headset with the phone.
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- Pairing to Additional Devices
- Adjusting Headset Volume
- Making and Receiving Calls
- Using Your Headset Indicator LED
- Pairing
DR
AFT
13
Pairing to Additional Devices
Your headset can store pairing information for up to eight
different devices with Bluetooth wireless technology. Devices
are stored in a “Paired Device List” in memory in the order
entered. When an attempt to pair to more than eight devices
is made, the oldest paired device is removed from the list.
Any of the eight paired devices can initiate a connection to
the headset.
The headset will only automatically initiate a connection
(upon power-up) with the
last
device it was
connected to
. If
you want to connect the headset to another device in the
paired device list, you must initiate the connection from that
device. Whichever of the eight devices initiates a connection
to the headset afterwards, that device then becomes the “last
connected” device.
Adjusting Headset Volume
Increasing or Decreasing Volume
To increase speaker volume, press the top volume button
repeatedly until you reach the desired volume level.
To decrease speaker volume, press the bottom volume button
repeatedly until you reach the desired volume level.