User Manual
Table Of Contents
- HS820 Wireless Headset with Bluetooth® Technology
- Welcome
- Contents
- Safety and General Information
- Introduction
- Using Your Headset
- Charging Your Headset Battery
- Wearing Your Headset
- Placing the Headset on Your Ear
- Changing for Wear on the Left Ear
- 1 Open the earhook (90˚ from the headset).
- 2 Gently lift and pull the top of the earhook up and off the upper hinge pin. Then pull it away to remove it.
- 3 Flip the headset over.
- 4 Hook the bottom of the earhook onto the lower hinge pin, then lift and pull the top of the earhook over the upper hinge pin.
- 5 To change the volume button orientation, see “Adjusting Headset Volume” on page 15.
- 1 Open the earhook (90˚ from the headset).
- Pairing Your Headset and Phone
- Pairing
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- 2 Perform a device discovery from the phone. For details on device discovery for your phone, refer to the phone’s user’s guide.
- 3 Select the Motorola HS820 from the discovered devices list and confirm following the on screen prompts.
- 4 When prompted by the phone, enter the passkey 0000 and confirm to pair the headset with the phone.
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- Pairing to Additional Devices
- Adjusting Headset Volume
- Making and Receiving Calls
- Using Your Headset Indicator LED
- Pairing
DR
AFT
12
Pairing Your Headset and Phone
Note:
You must pair your headset and phone before you can
make a call.
“Pairing” creates a link between devices with Bluetooth
wireless technology, and allows the phone to remember the
headset’s unique ID. When your headset and phone are
paired, your headset automatically connects to your phone.
Pairing
With the headset and phone close together:
Action
1
With the headset off, hold the Multifunction Button
until the LED remains on (about 3 seconds).
2
Perform a
device
discovery
from the phone.
For details on device discovery for your phone,
refer to the phone’s user’s guide.
When the scan is complete, the phone displays the
devices found.
3
Select the Motorola HS820 from the discovered
devices list and confirm following the on screen
prompts.
4
When prompted by the
phone, enter the
passkey
0000
and
confirm to pair the
headset with the phone.
The device ID is now
stored in the phone’s
memory.
Pairing is successful when
the headset indicator
flashes rapidly.