User Manual
Table Of Contents
- HS820 Wireless Headset with Bluetooth® Technology
- Welcome
- Contents
- Safety and General Information
- Introduction
- Using Your Headset
- Charging Your Headset Battery
- Wearing Your Headset
- Placing the Headset on Your Ear
- Changing for Wear on the Left Ear
- 1 Open the earhook (90˚ from the headset).
- 2 Gently lift and pull the top of the earhook up and off the upper hinge pin. Then pull it away to remove it.
- 3 Flip the headset over.
- 4 Hook the bottom of the earhook onto the lower hinge pin, then lift and pull the top of the earhook over the upper hinge pin.
- 5 To change the volume button orientation, see “Adjusting Headset Volume” on page 15.
- 1 Open the earhook (90˚ from the headset).
- Pairing Your Headset and Phone
- Pairing
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- 2 Perform a device discovery from the phone. For details on device discovery for your phone, refer to the phone’s user’s guide.
- 3 Select the Motorola HS820 from the discovered devices list and confirm following the on screen prompts.
- 4 When prompted by the phone, enter the passkey 0000 and confirm to pair the headset with the phone.
- 1 With the headset off, hold the Multifunction Button until the LED remains on (about 3 seconds).
- Pairing to Additional Devices
- Adjusting Headset Volume
- Making and Receiving Calls
- Using Your Headset Indicator LED
- Pairing
DR
AFT
9
How to Charge
Note:
You can also use a Motorola Original Vehicle Power
Adapter to charge the headset battery while in your vehicle.
A fully charged headset battery provides approximately:
•
6 hours talk time
•
100 hours standby time
Step
1
Plug the Motorola
charger into the
headset, with the
charger’s release tab
facing down and the
headset facing up.
2
Plug the other end of the charger into an electrical
outlet.
During charging, the headset indicator turns on and
remains on until charging completes. The headset
will not work while charging. Your headset fully
charges in approximately two hours .
3
When charging completes (indicator off), remove the
charger from the electrical outlet, press the release
tab, and detach the charger from the headset.
040057o
Release Tab
Facin
g
Down