User Manual

right page (17) of Bluetooth Headset multi, A30880-N7401-A100-1-SP19 (18. December 2003,
© Siemens AG 2001, L:\Mobil\Bluetooth-Headset\en\Bluetooth_Headset_en.fm
Headset PTT Bluetooth™ (en) 17
Switching the Bluetooth
headset on and off
Push the On/Off switch to the
ON position (I). The headset is
switched on. The LED flashes.
To switch off, push the On/Off
switch to the off position (0).
Resetting
To register the Bluetooth™
headset with another mobile
phone you must reset the head-
set to the default settings:
1. Switch the headset on (see
above).
2. Then press the PTT key and
the
key on the headset
simultaneously for at least
3 seconds. The LED will flash
rapidly five times.
The headset has now been reset
to the original default settings.
You can now register the head-
set with another mobile phone
(p. 16).
Calling
To use the headset to make a
call, the headset must be
switched on (see left) and a con-
nection must be established
with a mobile phone (p. 16).
The procedures described below
only apply to Siemens mobile
phones. Different procedures
may be required for mobile
phones made by other manufac-
turers.
The following symbols are used
to explain operation:
L
Function depends on the
service provider; special
registration may be neces-
sary.
• You will know that a call is about to
be interrupted if the signal quality is
poor.
• If the mobile phone is not con-
nected to the network you will hear
a repeated high-pitched tone in
your headset.
• If the Bluetooth™ connection to the
mobile phone is interrupted for sev-
eral seconds during a call, you can
only continue the call from the
mobile phone.