User Manual

© Siemens AG 2001, L:\Mobil\Bluetooth-Headset\en\Bluetooth_Headset_en.fm
left page (16) of Bluetooth Headset multi, A30880-N7401-A100-1-SP19 (18. December 2003,
Headset PTT Bluetooth™ (en)
16
.
1. Insert the charging device
connector
o
into the
headset
n as shown.
2. Insert the mains plug on the
charging device into the
mains socket.
Charging time
An empty battery is fully
charged after about 2.5 hours.
Display while charging
The headset switches off auto-
matically when it is connected to
a charging device. The LED is red
during charging. When the bat-
tery is fully charged the LED
turns green.
Registering the headset with
a mobile phone
The headset must be switched
on.
1. Hold down the mute key and
the
Ò key simultaneously for
at least 3 seconds. The LED
will come on. Your mobile
phone can now "search" for
the Bluetooth™ headset.
2. Activate search mode on your
mobile phone. To do this
please read the notes in the
user guide for your mobile
phone.
3. When the mobile phone finds
your headset this will be
shown on the mobile phone
display with the device name
HHB-600.
4. If requested, enter the pass-
word (PIN) for the headset
into your mobile phone:
0000.
The Bluetooth™ headset is now
registered with the mobile
phone.
Only charge the battery when the tem-
perature is between 0 °C and 45 °C.
Otherwise it will wear out prematurely.
n
o
If your mobile phone cannot find the
headset within 3 minutes you will need
to reactivate search mode (repeat
step 1).